We like this product due to the fact that it has a brush-to-port suction for an excellent vacuuming of acorns, leaves, and fine debris as well. We don't like that it cannot clean the steps of your swimming pool.
Cleaning your swimming pool is essential for your safety. It is important to use the right cleaner in order to obtain the best results. Therefore, what you must do is to opt for a product just like the Smartpool NC52 Wall Climber. It is excellent for in-ground pools up to 20 x 40 x 8 inches deep. It is very easy to use, with lots of wonderful features, and reasonably priced as well. Therefore, if you think you need a device like this and if you would like to learn more about this product, then you must definitely have a look at this review in order to find all the information you need.
It can clean and brush extremely well the floor and walls of your swimming pool. Unfortunately, it cannot climb steps. There are 2 cleaning modes that help you obtain wonderful results. The first one is a 3-hour standard cleaning mode and the second one is a 1-hour rapid cleaning mode. The device has a brush-to-port suction for an excellent vacuuming of acorns, leaves, and fine debris as well, and a direct drive motor for greater traction. This is a highly recommended cleaner for all pool surfaces such as vinyl liner, concrete, and fiberglass. The back brush makes sure it scrubs all the dirt and algae on the pool’s surface so it will be able to perform a thorough cleaning. Another wonderful thing about this device is that it features advanced pool robotics technologies, like smart navigation, which will actually allow it determine the best cleaning path.
The NC52 has a revolutionary lightweight design, which means that you will easily carry it from a place to another. Thanks to the large handle at the back, you will be able to easily submerge the cleaner into the pool, take it out, and carry it around. It has a 600-inch power cord and an extra-large filter bag capacity. It measures 17.5 x 15 x 13.2 inches, it weighs 17.9 pounds and it is available on the market with a black and blue finish. The wheels and the back brush provide traction although not enough to propel the pool cleaner up the walls. A transport caddy can be bought separately.
Thanks to the ultra quick-drain system that it comes with, a lightweight removal from the pool is possible. You need to slowly pull the blue cord to get the device to the pool surface and near the edge of the pool. Reach down and grasp the handle of the robotic pool cleaner in order to remove it from the pool. Even though it does not come with a transport caddy it is still very easy to move from place to place due to its lightweight design and convenient handle. Unfortunately, it does not come with a remote control either. However, using it is quite simple. What you need to do is to plug the power supply into the GFCI or ELI protected outlet and then plug in the connector from it into the socket. Once you do so you must place the robot pool cleaner into your swimming pool and rock it from side to side in order to release any trapped air. It will quickly sink to the bottom of the pool and do its job. Do not forget to choose the desired cycle. The device will actually shut itself down automatically after the selected cycle has been completed.
The Smartpool NC52 Wall Climber is an energy-efficient robot pool cleaner that will definitely help you cut down electricity costs, due to the fact that it actually operates independently of your pool pump and filter. It also helps the environment even more by considerably reducing the pool chemical consumption. The water conservation will also be increased by reducing the need to backwash your pool filter. Moreover, due to the smart navigation that calculates the shortest path, the energy consumption will be significantly reduced. Also, the cleaner turns off automatically so energy waste will be prevented. We did not find any information regarding the exact energy consumption.
This robotic pool cleaner comes with a 3-year limited warranty, which is quite good, compared to other products in this category that only have a 1-year warranty. The first year you get full coverage on manufacturer defects, the second year you get 100% coverage on the pump and drive motors, and the third year you get 50% coverage on the pump and drive motors. This warranty does not include replacements for the brushes, bottom lid, and filter bag. This is an ETL, CSA, and CE Approved product. For further information about it, customers can contact the friendly Customer Service department.
If you are always on the run, then the NC52 is the right pool cleaner for you. The fast 1-hour cleaning mode that it allows you to opt for makes it possible to get the pool clean fast in case you have guests over and they announce of their presence at the last minute. But what impressed us the most when reviewing this cleaner was not the quick cycle alone as there are other important highlights to be mentioned as well. We must underline the usefulness of the smart navigation function of the robot again as it not only delivers shorter pool cleaning times but because it adds to the energy efficiency of the product as well. Always taking the shortest cleaning route possible when cleaning the water and surfaces of the pool, this robot is hard to beat when it comes to low operational costs. All in all, it is an option worth taking into consideration and one that we strongly recommend to people who own pools of up to 40 feet in length.